Clone stamp doesn't work properly after reloading project file
Posted: 25.05.2019 17:53
Hi Stas,
I reported this issue in March (HF7.5.1). Now we have HF 7.5.4 and there is still the same problem:
After reloading a project file, in retouching mode there is a significant offset between the two brushes...
What can I do??
Best regards
Michael
I reported this issue in March (HF7.5.1). Now we have HF 7.5.4 and there is still the same problem:
After reloading a project file, in retouching mode there is a significant offset between the two brushes...
What can I do??
Best regards
Michael