blurry effect in stacking

Announcement of new releases, bugs, support, suggestions
Post Reply
denisg
Posts: 13
Joined: 17.07.2018 00:29

blurry effect in stacking

Post by denisg » 30.01.2020 18:07

hello I would like to know how to avoid this blurry effect in the background
bague 7690 1.jpg
(1.79 MiB) Not downloaded yet
bague 7690 2.jpg
bague 7690 2.jpg (682.13 KiB) Viewed 6906 times

knog17
Posts: 9
Joined: 20.12.2018 22:58

Re: blurry effect in stacking

Post by knog17 » 31.01.2020 15:21

I don't think you can avoid it.
Look which render method works best for your motive, then repair such flaws with Retouching tools in Helicon as good as possible.
Ideally use Photoshop after that for a clean finish.

User avatar
Catherine
Posts: 339
Joined: 29.04.2019 22:38

Re: blurry effect in stacking

Post by Catherine » 11.02.2020 09:57

There is no direct and straightforward solution, but you have a couple options:
a) Use rendering method C or A.
b) Use method B, but reduce the radius and smoothing values.
c) Render with method B, then C. Then go to retouching and patch the problematic areas on the B result using the C result as source.

Davey-2
Posts: 2
Joined: 13.01.2020 00:27

Re: blurry effect in stacking

Post by Davey-2 » 18.02.2020 04:57

Please explain how one can one use one image rendered from A or C to patch a B rendering

Couldn't figure it out

thanks

User avatar
Catherine
Posts: 339
Joined: 29.04.2019 22:38

Re: blurry effect in stacking

Post by Catherine » 21.02.2020 07:39

Davey-2 wrote:
18.02.2020 04:57
Please explain how one can one use one image rendered from A or C to patch a B rendering
After you've finished both renderings (say, B and A), you can click the B result, go to Retouching, then click "Use another output as source" under the list of source images and select the A result. Now you can proceed to copy parts of the A image onto B using retouching "Copy" brush.

Post Reply