Page 1 of 1

Filename default when saving output.

Posted: 10.12.2021 15:42
by jdolson
Filename default when saving output.

When I render a stack, I see an output file in the bottom left that shows "C 2", or "A 8 2". This is a very nice, compact way to describe the method and parameters. I've attached an image showing an example, along with the Output filename template.

However, when I save the output file using that template, it generates an overly long file name showing the full words "Radius", and "Smoothing". See second attached image.

I can manually reduce each file name to something like "A 8 2", but it's not fun when doing lot's of work.
Is there any way to modify the ([PARAMS]) format to not show the words Radius and Smoothing?

Re: Filename default when saving output.

Posted: 13.12.2021 00:09
by Catherine
Thank you for your input, that's a good point. We will shorten it to 'S' and 'R'.

Re: Filename default when saving output.

Posted: 13.12.2021 09:42
by BobStone
Hoping for that change! Asked the same a few years ago ...

Re: Filename default when saving output.

Posted: 13.12.2021 18:40
by jdolson
Thanks Catherine :-)