Hello,
my community and me are using Helicon Focus for micro mineral photography. Our stacks are often more than 100 images. I will use helicon remote together with an arduino board to control my z stage. Is there a way to bring helicon remote together with an arduino board which also can be controled by serial commands.
The goal should be to set a start point, an andpoint and the numer of steps and the rest should do helicon remote. Make a picture drive some steps, wait a few seconds ... and the same again.
I already saw you did the same with trinamic stepper motors. This motors are very expensiv and difficult to get. For my arduino board, stepper motor and drive all to gether i spend less then 10€.
Kind regards Stefan
Arduino and Helicon Remote
- Stas Yatsenko
- Posts: 3841
- Joined: 06.05.2009 14:05
- Contact:
Re: Arduino and Helicon Remote
You could download the serial protocol documentation for Trinamic and implement it in your Arduino board.
Re: Arduino and Helicon Remote
Hello, thank you for the hint and sorry for the delay of my answer.
Re: Arduino and Helicon Remote
Stefan, did you come to success in mating Helicon Remote and Arduino? If yes, could you post solution?
-
- Posts: 4
- Joined: 14.04.2022 21:30
Re: Arduino and Helicon Remote
Stefan,
Have you had any success with this implementation?
Have you had any success with this implementation?